• An embedded NAND-type
Flash memory chip
• Rapid write and erase capabilities
• Improved performance through continuous data
recording
• 8-bit I/O interface
•
Serial page access: 50ns (minimum)
• 1-years
Warranty
This installation guide supports Transcend’s TS16MVSSFDC,
TS32MVSSFDC, TS64MVSSFDC, and TS128MVSSFDC SmartMedia
Cards. Media Handling
In order to maximum the life and use of your SmartMedia
Card, please follow these precautions:
1. Avoid bending or exposing the card to excessive heat.
2. Avoid storing the card in places with high humidity
and/or static electricity.
3. Handle the card by its edge and avoid touching the
metallic contact surface.
4. Do not remove the card while it is being used. Installation Procedures
Please read the following instructions for general installation
and usage of SmartMedia Cards. Refer to your device’s
owner’s manual for specific issues.
1. Turn off the device.
2. Insert the storage card into the device. The storage
card
has a key notch preventing it from being improperly
inserted.
3. The card should slide freely into the slot until
it reaches
the bottom, at which point, you will feel some resistance.
Check for obstructions if the card does not slide into
the
slot freely.
4. Installation is now complete. Notes
1. Write-Protection: Apply the metallic, adhesive
write-protect sticker over the circular dot (B in the
following illustration) to prevent recording over
information you wish to archive.
2. Data Transfer: Your device(s) should be provided
with all
the necessary software and hardware to transfer
information from the SmartMedia Card to your computer.
3. Format: Be careful! Do not re-format your SmartMedia
card before usage.
| 
